Beijer-electronics RBC EN Manual do Utilizador descarregar pdf (Página 6)

Hardware

1.1.2 Buzzer In/Ou t Pin Conﬁguration

There is a buzzer integrated in the front behind the front foil. It can be turned on

or off by a SCOM compatible RBC software command.

It can also be activated by the buzzer-in hardware input according to the following

table.

The resulting buzzer-in signal is evaluated by an OR operation on the signals from

software and h ardware.

Buzzer-out is a relay contact parallel to the integrated buzzer that can be used to

switch an external signal device.

The buzzer-in and -out can be connecte d to the 4-pole Phoenix connector:

1 4

Pin Designation Function

1, 2 Out Buzzer-out, NO-contact, max. load 1 A @ 24 V DC

3 In Buzzer-in, +24 V DC

4 In Buzzer-in, ground

Related information

Buzzer In/Out

1.1.3 Power Remote Pin Conﬁguration

Remote power out is a relay contact that is closed after the power button on the

front side is pressed for mo re than one second. It is opened after the button is

released. With the remote power out signal, it is possible to switch an external

Beijer Electronics EPC Nautic on and off. The EPC has a corresponding AT X

power remote input. To use this function, connect the double-pole Phoenix

connector to the corresponding connector on the EPC.

Pin Designation Function

1, 2 O ut Remote Power, NO-contact

To be connected to a Beijer Electronics EPC power remo te

input.

Beijer Electronics, MAEN986C

1 2 3 4 5 6 7 8 9 10 11 ... 24 25

Sem comentários

Beijer-electronics RBC EN Manual do Utilizador Página 6