Beijer-electronics RBC EN Manual do Utilizador descarregar pdf (Página 11)

Firmware

2.1.1 Using Software Settings Instead of

DIP Switches

The DIP switches can be used to adjust the mode of the serial interfaces as well as

the monitor address. By default, DIP switch settings are used.

Alternatively, it is possible to ignore the DIP switch settings; instead using software

settings for address and serial mode. DIP switches allow addresses from 0.0

(Group.Address) to 0.15, i.e. 16 different addresses, always in group 0. Software

settings allow addresses from 0.0 to 14.15, i.e. 240 different addresses in 15

different groups.

Make sure to use every monitor address in a network only one time.

2.1.2 Remote Control

TheRemoteControlfeaturespeciﬁesifthemonitorshouldbeabletocontrol

the backlight brightness of other monitors (default) or not. If remote control is

enabled, all monitors to be controlled must be reachable. That means that exactly

one monitor can be connected using the RS232 interface or several monitors can

be connected using th e RS485 interface. Another possibility is to connect this

monitor to a PC (using RS232, RS485 or USB) where the RBC Router is running.

Depending on the conﬁguration of this RBC Router, it is possible to control all

connected monitors.

If only one of the dimmer b uttons is pressed, the remote control command is

transmitted when the button is released. If both dimmer buttons are pressed, the

command is transmitted after one second, if conﬁgured.

Related information

Remote Dimming

Keypress Mode

2.1.3 Default Brightness

TheDefaultBrightnesscanbeusedaskeypressbrightnessorasstartupbrightness

after power on or reset. The range is from 0 (darkest) to 255 (brightest).

Related information

Keypress Mode

Startup Brightness Mode

Beijer Electronics, MAEN986C

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 24 25

Sem comentários

Beijer-electronics RBC EN Manual do Utilizador Página 11