Beijer-electronics iX Panel T40 EN Manual do Utilizador descarregar pdf (Página 22)

Hardware Replacement

7.4 ReplacingtheDisplay/Display

Cable

The following is needed:

• A new display including display frame, see

Available Spare Parts for iX Panel T40

• AtorxT10screwdriver

• Two plain screwdrivers

Note:

MakesuretouseadequateESDprotection.

Follow the steps below to replace the display/display cable:

Power off the operator panel.

Follow the instructions under Replacing the Rear Cover to remove the rear

cover.

Unlock the ﬂex cable connector by pressing the connector ﬂanges towards the

cableanddisconnecttheﬂexcableandtheplaincablefromthepowercard.

The connector must be unlocked on both sides before removing the cables.

power card

flex cable

plain cable

Gently press the power card towards the top of the panel as shown in the

illustration above to release the power card from th e power card hold ers. Then

tilt the bottom of the card away from you.

Disconnecttheﬂexcableonthebacksideofthepowercardandremovethe

power card.

BeijerElectronics, MAEN004

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 44 45

Sem comentários

Beijer-electronics iX Panel T40 EN Manual do Utilizador Página 22